Go full screen 1024x768 where possible with Millions of colours....JAVAand FRAMES enabled Browser . FLASH plug-in required. 

HOW TO MAKE A CLOWN FRILL IN ZBRUSH

I needed a Clown Frill for an image (see left) and this is how I made it.

-Select TOOL/CIRCLE3D

-Go to MODIFIERS/INITIALIZE/ and use these parameters:

INNER RADIUS START: 30
INNER RADIUS END : 30
HDIVIDE : 128
VDIVIDE : 128

-It should look like (1.)

when you draw it into the document. -Enter EDIT mode (Press `T`)

-When in EDIT mode go to TOOL/SYMMETRY and press `Z` and `R` (radial)

. -Set the radial count to 10. (3.)

-Still in EDIT mode go to TRANSFORM/DRAW POINTER. Set the DRAW size to about 20. Begin to raise up the frills with short strokes (3.) Make hills and troughs using the ALT key to push downwards. You may need to flip to TRANSFORM/MOVE now and then.

If things get too bumpy use TOOL/MODIFIERS/DEFORMATIONS/SMOOTH set to 100 a couple of times. It should start to look like (5.)